static pressure

英 [ˈstætɪk ˈpreʃə(r)] 美 [ˈstætɪk ˈpreʃər]

网络  静压; 靜壓; 静压力; 静压强; 风压

化学



双语例句

  1. A Study on Characteristics of Air Static Pressure Thrust Bearing with Variable-Section Pressure Equalizing Groove
    具有可变均压槽的气体静压推力轴承性能研究多孔质气体润滑轴承设计理论与实验方法
  2. Formulas of axial forces in working cells of hydraulic torque converter are presented on the analysis of the distribution of static pressure on working cells of hydraulic torque converter.
    对石油钻机液力变矩器各工作轮中液体的静压力分布进行了分析,由此得出了液力变矩器各工作轮轴向力的理论计算公式。
  3. A small hole in the fuselage for sensing static pressure for airplane instruments.
    位于机身外表,用来为飞机仪表感应静压的小孔。
  4. Efficient, low-noise level, Multipurpose for air flow and static pressure.
    低压、中压和高压。高效,低噪音,多用途。
  5. As the reaction of leakage flow, static pressure troughs formed in the outer wall case are enlarged with the increase of clearance and backpressure.
    作为泄漏流的反应,外壁机匣上所形成的静压槽随着间隙的增大、反压的提高而扩大;
  6. The static pressure loss coefficients, total pressure loss coefficients and flow outlet angle distribution are simulated in conditions of different setting angles.
    分析在不同叶片安装角下,叶片表面静压系数、出口总压损失系数和出口气流角的变化规律。
  7. Seepage Control Effect of Static Pressure Grouting in Dam Shell for Danjiangkou Earth-rock Dam ⅰ: Two-dimensional Seepage Calculation
    丹江口土石坝砂卵石坝壳静压注浆渗控效果研究Ⅰ:二维渗流计算
  8. Predict the properties of journal bearing under dynamic pressure, static pressure and combination pressure.
    对液膜轴承动压、静压和动静压混合状态下的径向滑动性能进行完整预测。
  9. The characteristics of static pressure changing at stage exits of a multi-stage axial flow compressor relative to the design points at several typical operating modes are investigated.
    对多级轴流式压气机在几个典型工况下各级静压相对于设计点静压的变化特性进行了研究。
  10. An instrument used to measure static pressure in a stream of fluid.
    在一股流动液体中测量静态压力的仪器。
  11. With low noise, high static pressure and high efficiency.
    噪声低、静压高、效率高。
  12. The static pressure decreases with the increase of wall roughness in the outer vortex region.
    外旋流区的静压力随着粗糙度的增大而明显减小。
  13. The large grinding machine specifications and other heavy-duty, precision equipment on the current closed guide the application of static pressure and the method of installation and debugging.
    介绍了大规格磨齿机和其他重型、精密设备上恒流闭式静压导轨的应用、计算方法及调试安装。
  14. The effects on solids holdup of heat exchanger tube, bed height, static pressure drop and average solids holdup of inlet chamber by superficial velocity were studied in different main distributors.
    在不同结构形式的主分布器条件下,研究了表观液速对换热管中固含率、下管箱内床层高度、静压降及平均固含率的影响。
  15. Dynamic-static Pressure bearings for cement mill and static Pressure reformation to its oil supplying system
    水泥磨动静压轴承及其供油系统的静压改造
  16. Combined Pitot tube and static tube that measures total and static pressure; used in aircraft to measure airspeed.
    测量总压力和静态压力,把皮托管和静态管组合起来;通常用于航行器的测量。
  17. On the static pressure method construction of PHC prestressed pipe piles and the quality control
    浅谈PHC预应力管桩静压法施工与质量控制
  18. This paper states some problems in static pressure tube pile construction according to engineering practice and accident analysis of construction quality supervision.
    根据静压管桩施工质量监督的工程实践及事故分析调查,阐述了静压管桩施工中应注意的几个问题。
  19. Volute tongue sets up a circumferential disturbance of splitter inlet static pressure near the cover of impeller;
    蜗舌结构导致短叶片轮缘静压分布的周向不均匀性;
  20. The distributions of energy loss and static pressure in each impeller under the typical working conditions were calculated after determining the circulated fluid flow.
    在确定了循环流量的基础上,计算了典型工况下各工作轮上的损失能头及静压力分布。
  21. The static pressure at the sample surface is also recorded.
    试件表面处的静压也能记录下来。
  22. This paper introduced hydraulic expansion sleeves ( static pressure expansion arbor) which clamp disk milling cutter and clamp stress locking cutting tool-holder.
    介绍了夹持片状盘铣刀的液压轴套(静压膨胀芯轴)和夹持指状铣刀的应力夹紧式刀具夹头。
  23. This paper deduced the flow stress of copper column that was under the action of static pressure, and it analyzed the influences of the pressure and temperature.
    文中推导了铜柱在静压下的流动应力,分析了压力及温度对铜柱压后高的影响。
  24. Comparison of several calculation methods of static pressure pile sinking resistance pressure
    几种计算静压桩沉桩阻力方法的比较
  25. The more convergence angle increases, the greater dynamic pressure, static pressure and total pressure rise.
    当合流角增加时,动压、静压、全压均会增大,且角度越大增幅越明显。
  26. For the limitations of exit static pressure of fan coil, the deviation between designed and actual resistance will impact on the wind.
    风机盘管机组由于出口静压的局限性,一旦设计阻力与实际阻力有偏差,对风量会产生很大影响。
  27. Static loading tests and numerical analysis of the FLAC~ ( 3D) settlement about the static pressure pipe pile
    静压PHC管桩静载试验及FLAC~(3D)沉降数值分析
  28. Differential pressure gauges model selection primarily looks at the following key features: measuring range, static pressure and the ratio between the two.
    差压压力表的的选型主要看量程、静压和两者之间的比例关系。
  29. The performance of rectangular compressor cascades composed of different swept blades was studied by static pressure measurement, flow visualization and probe measurement.
    通过壁面静压测量、流场显示及气动探针测量研究了不同掠型叶片组成的平面扩压叶栅特性。